三级2017在线观看免费_婷婷色五丁香_亚洲天堂视频一区_国产无遮挡又黄又爽奶头_亚洲无码在线免费视频_舌吻哼哼唧唧原声不带歌_一级做a爰片毛片潮喷中文字幕无码精品_2020国产精品国产精品_脫了動漫美女內褲猛烈進入gif_人妻中文字字幕在线乱码

DS3800HCMA
故障回路不影響接地系統，基本上由相導體和保護導體串聯而成。根據IEC 60364-4規定，為提供自動斷開電路的保護，應滿足以下條件：Zs·Ia≤ U0，其中：Zs是故障回路的阻抗，包括電源、故障點之前的帶電導體以及故障點和電源之間的保護導體[?]; U0是標稱交流r.m.s.接地電壓【V】；I a是保護裝置在表3中規定的時間內的斷開電流（安培），作為電流不超過32A的終電路的額定電壓U0的函數，或配電電路和電流超過32A的終電路在5秒內的函數（對于電路類型的描述，應參考TT系統給出的指示）.應通過適當協調斷開時間和故障回路阻抗，選擇自動裝置，以防止相位PE故障和間接接觸。在TN系統中，低壓側的螺栓故障相PE通常會產生類似于短路的電流，接地故障電流流經線路導體（或多個導體），而保護導體不會影響接地布置。Zs·Ia關系≤ U0可表示為：I a≤ U0=IkLPE Zs，其中IkLPE是相位PE故障電流。因此，可以說明，當保護裝置的跳閘電流I a（在表3所示時間內或5s內）低于待保護外露導電部分的相PE故障電流IkLPE時，可驗證間接接觸保護。在TN系統中，以下裝置用于防止間接接觸：•帶熱磁脫扣器的斷路器；•帶電子脫扣器的斷路器剩余電流裝置（僅TN-S）。

The fault loop does not affect the earthing system and is basically formed by the connection in series of the phase conductor and of the protective conductor. To provide a protection with automatic disconnection of the circuit, according to IEC 60364-4 prescriptions, the following condition shall be fulfilled: Zs · Ia ≤ U0 where: Zs is the impedance of the fault loop comprising the source, the live conductor up to the point of the fault and the protective conductor between the point of the fault and the source [?]; U0 is the nominal ac r.m.s. voltage to earth [V]; I a is the disconnection current in amperes of the protective device within the times defined in Table 3 as a function of the rated voltage U0 for final circuits with currents not exceeding 32A or within 5 seconds for distribution circuits and for final circuits with current exceeding 32A (for a description of the circuit typologies reference shall be made to the indications given for TT systems).The choice of the automatic device for the protection against phase-PE faults and against indirect contact shall be carried out by coordinating properly the disconnection times with the impedance of the fault loop. In TN systems a bolted fault phase-PE on the LV side usually generates a current similar to that of a short-circuit and the earth fault current flowing through the line conductor (or conductors) and the protective conductor does not absolutely affect the earthing arrangement. The relationship Zs · Ia ≤ U0 may be expressed as: I a ≤ U0 = IkLPE Zs where IkLPE is the phase-PE fault current. Therefore, it is possible to state that the protection against indirect contact is verified when the tripping current I a of the protective device (within the times shown in Table 3 or within 5s) is lower than the phase-PE fault current IkLPE at the exposed-conductive-part to be protected. In TN systems the following devices are used for protection against indirect contact: • circuit-breakers with thermomagnetic releases; • circuit-breakers with electronic releases; • residual current devices (TN-S only).